Freewheel
PB Cam Clutch
The PB cam clutch uses a plain bearing between the outer race and the shaft to keep the inner and outer races concentric and to support the radial load. Therefore, the PB cam clutch requires the shaft to extend through the outer race end.
AS Roller Type Freewheel
Type AS is a roller type freewheel non-bearing supported. Bearings are required to support axial and radial loads. Lubrication and sealing must also be provided by the installation. Nominal outside dimensions are the same as series Dall bearings. A typical arrangement is to install this type alongside a series 62 bearing within the same location tolerances.
ASNU Roller Type Freewheel
Type ASNU is a roller type freewheel non-bearing supported. Bearings are required to support axial and radial loads.Lubrication and sealing must also be provided by the installation.
AE Roller Type Freewheel
Type AE is a roller type freewheel non-bearing supported. Bearings are required to support axial and radial loads. Lubrication and sealing must also be provided by the installation. Nominal outside diameter is a standard ball bearing dimension.
GFK sprag freewheel
Type GFK is a sprag type freewheel integrated into a 59… series ball bearing. This design provides high torque capacity for minimal outside diameter. It is a bearing supported type, delivered grease lubricated. Oil bath lubrication is also possible.
FE Sprag Type Freewheel Cage
FE are all sprag types freewheel cage without inner or outer races. They must be installed in a design providing races, and bearing supported for axial and radial loads.
CSKP Sprag Type Freewheel
Types CSKP and CSK.PP are sprag type freewheels integrated into 62.. series ball bearings (except size 40). They are bearing supported, delivered grease lubricated and protected against dust of more than 0,3 mm. The use of additional “ny-los”type seals is recommended especially when the working temperature exceeds 50’C. Oil bath lubrication is also possible.
CSK Sprag Type Freewheel
Type CSK is a sprag type freewheel integrated into a 62 series ball bearing (except sizes 8 and 40), It is bearing support ed, delivered grease lubricated and protected against dust of more than 0,3 mm. The use of additional “nylos” type sealsis recommended especially when the working temperature exceeds 50°C. Oil bath lubrication is also possible.
DC Sprag Freewheel Cage
Type DC is a sprag type freewheel cage without inner or outer races. It must be installed in a design providing races, bearing support for axial and radial loads, lubrication and sealing.